Hello, I'm currently working on a non-flyer, resto project in Western New York. Huey was on a flat pad from 1995. Tried to pull the mast out of the trans- no luck. ( trying to do that because the local Town gave us a "bay" in thier Highway dept. garage to use for the project, but doorway wasn't high enough to roll her in there) Plan "B", pull the whole mast/trans as a unit. Did that. Problem #1 is, sometime during time spent on the pad, blades broke free and now, they won't turn. trans was dry, later found out trans case is cracked. Going to seal that and try to fill it to the brim with ATF and see if it will help to break it free. T/R output shaft seal is leaking, and I'm looking to "rent" special tool #T60, to remove it, and replace it. Tried to move nut , no joy... Had a 48" pipe wrench on the K-Flex, input to trans, no luck. Right now, looking for any help. Thanks so much.
top of page
bottom of page